NEW! Bump Steer Kits
NEW!
• Correct Bump Steer Issues
• Re-align your rack for
your current ride height
• Improve Your Vehicle’s Handling
®
®
Has the height of your suspension been altered from the original specs? Flaming River now has a solution to
improve your handling issue. Our new bump steer kit has been designed to assist you in re-aligning your steering
geometry. Simply replace your current outer tie rod ends with the new tie rod ends, using the provided spacers
to adjust the angle as needed. These adjustable outer tie rod end replacements feature 6061 T-6 aluminum, fully
machined sleeve with a black anodized finish, a Teflon lined 5/8” heim joint and 4140 steel pin which. The pin is
machined with the correct taper for the spindle. Teflon-lined heim reduces noise and does not require lubrication.
Racing/Mustang Bump Steer Kit
FIG A
FIG B
FIG C
Viewed from the front of the car, the tie rods should be parallel to the
A-arms. Figure A shows the tie rod too high. Need to add more spacers
between the spindle and tie rod end. Figure B is an example of the correct
spacing. Figure C shows the tie rod too low. Need to add fewer spacers
between the spindle and tie rod end.
65-70 Mustang
FR1619MU
67 Camaro
FR1619CA1 68-69 Camaro
FR1619CA2
Mustang kit designed for the Granada spindle.
Please note: Bump Steer Kit can only be used with male inner ends
(not furnished).
Bump Steer Kits
Part No. Application Spindles
FR1619MU 65-70 Mustang Granada
FR1619CA1 67 Camaro Original
FR1619CA2 68-69 Camaro Original
163